Bluetooth Controller:

• Requires 12V power source
• Requires 1 3/8" diameter hole
• Dimensions (W x D)2" x 2"
• Wireless Bluetooth Streaming
• IPX6 Waterproof
• Flush Mount

Speaker:

• Power Handling: 100 watts RMS, 300 watts peak power
• Sensitivity: 92dB at 2.83 volts
• Frequency Response: 40 - 25kHz
• Voice Coil Diameter: 1 in. (25.5mm)
• Impedance: 3 ohm impedance
• DO NOT USE DRILLS ON THE SCREW SPEAKER TERMINALS EVER.

• Loosen and Tighten BY HAND ONLY.  Using a Drill snaps the solder connection on the back of the terminal and the X-over (coax) Circuit board.

Amplifier:

• 4 Channel Marine Amplifier
• 75 watts RMS x 4 at 4 ohms
• 100 watts RMS x 4 at 2 ohms
• 200 watts RMS x 2 at 4 ohms in bridged mode (4-ohm stable in bridged mode)
• Class H amp technology
• Variable high and low-pass filters on front and rear channels
• Preamp outputs
• Fuse rating: 30A x 2
• 8-gauge power and ground leads recommended

Amplifier Wiring Kit:

• Designed tor motorcycles
• 6 feet of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder and 60 amp fuse protected by a black nylon braid
• Pre-terminated ring terminals make connections to the battery simple
• Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
• Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
• All the necessary installation hardware is included along wtth a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place